Parkside PSB 1050 A1 - 3, Manual

Page: 9 / 34

10 GB/IE/CY
If the inserted tool jams, switch off the
electrical power tool immediately.
Be
prepared for high reaction torques as they may
cause kickback.
Always keep the device clean, dry
and free of oil or grease.
When carrying out work during which
the insertion tool could hit hidden
power cables or the power cable of the
appliance itself, hold the appliance by
the insulated handling surfaces.
Contact
with a live cable can also make metal appliance
parts alive and cause an electric shock.
Keep your workplace clean and tidy.
Mixing materials is particularly dangerous.
Dust from light metals can burn or explode.
Wait until the electrical tool has come
to a standstill before putting it down.
The insertion tool could get caught up in some-
thing and this may lead to control of the electrical
tool being lost.
Caution utility services!
DANGER! Ensure that you do not strike
electrical cables, gas or water pipes when
you are working with the electrical power
tool.
Check a wall using a suitable detector before
you drill or cut slots.
Original accessories /
attachments
Use only the accessories and attachments
detailed in the operating instructions.
The use of inserted tools or accessories other than
those recommended in the operating instructions
could lead to you suffering an injury.
Before first use
WARNING!
DANGER OF INJURY!
Switch
the device off and pull the plug out of the mains
socket before carrying out any work on the device.
Mounting or adjusting
the additional handle
NOTE:
For reasons of safety, you may only use
this appliance with a properly mounted additional
handle
10
.
Turn the wing screw
9
anti-clockwise and
mount the additional handle
10
in the vertical
position. The ratchet settings have be pushed
over the two green locking pins on the spindle
neck of the appliance.
Tighten the wing screw
9
by turning it clock-
wise.
NOTE:
Adjust the additional handle
10
into the
various ratchet settings according to the position
you are working in. To do so, loosen and close the
additional handle as described above.
Using the depth stop
Loosen the wing screw
9
.
Pull the depth stop 8 out as far as necessary
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
Firmly tighten the wing screw 9 .
Inserting tools
Quick-action drill chuck / spindle lock:
Your percussion drill has a fully automatic spin-
dle lock
and is fitted with a single-sleeve
drill chuck with radial lock “Made in Germany”
by
.
When the motor comes to a standstill, the drive
train will lock so that you can open the quick-
action drill chuck
1
by turning it .
After you have inserted the tool you wish to
use, turn the drill chuck
until you cannot
hear any more clicks. The drill chuck will lock
automatically. The spindle lock releases itself
automatically when the motor is started (by op-
eration of ON / OFF switch
4
).
General safety advice for electrical power tools / Before first use