Parkside PPS 40 A1, Operation And Safety Notes Translation Of The Original Instructions

Page: 39 / 109

39 GB/IE
Troubleshooting
Faults Cause of fault Troubleshooting
Indicator lamp
does not lit up?
„
No electrical connection.
„
ON/OFF switch set to off.
„
Check power cable.
„
Set switch to ON.
Ventilator does
not work?
„
Power line interrupted.
„
Power line ventilator faulty.
„
Ventilator faulty.
„
Check power line.
Warning lamp
switches on?
„
Overheating protection
switched on.
„
Input voltage too high.
„
Allow device to cool down.
„
Input voltage according
to type plate.
No output
current?
„
Machine faulty.
„
Overvoltage protection
activated.
„
Machine must be repaired.
„
Allow device to cool down.
Output current
does not
decrease?
„
Input voltage too low.
„
Connection cable cross-section
too low.
„
Observe input voltage
according to type plate.
Air current cannot
be regulated?
„
Compressed air hose
damaged or faulty.
„
Valve/manometer fails.
„
New connection of the hose.
HF-arc is not
created?
„
The burner switch is faulty.
„
Soldering point on the burner
switch or plug loosened.
„
Valve/manometer fails.
„
Renew electrode.
Bad ignition?
„
Burner wear parts damaged
or worn.
„
Check HF spark gap.
„
Change wear parts.
„
Set spark gap.
Pistol is not ready
for operation?
„
Current switch is switched off.
„
Air transmission is restricted.
„
Workpiece is not connected to
the ground terminal.
„
Switch the current switch to
‘on’.
„
Another indication of this is
a green flame. Check the air
supply.
„
Check the connection.
• Troubleshooting