Parkside POF 1200 C2, Translation Of The Original Instructions

Page: 35 / 140

35
IE GB
Troubleshooting
Problem Possible cause Error correction
Appliance does not
start
No mains voltage
Main circuit breaker is tripped
Check the socket, power cable,
line, power plug, repairs to be
carried out by qualified electri-
cian if necessary, check main
circuit breaker.
On/off switch ( 6) is broken
Repair by Customer Care
Motor faulty
Engine is slower
and stops
Device is overloaded through
workpiece
Reduce the pressure
Increase rotation speed
Workpiece unsuitable
The milling is not
straight
The guide bars ( 29) of the
parallel stop ( 24) are not
mounted firmly.
If necessary, retighten the screws
of the guide bars.
The milled work-
piece has burn
marks
Rotation speed too low Increase rotation speed
Unsuitable or blunt cutter Change the cutter
Cutting depth is set too large
Use the step stop to mill in multi-
ple steps
The fringes of the
milled part tear off,
there are grooves
and uneven parts
in the milling
Cutter is worn out and dull Change the cutter
Cutter blades are damaged Change the cutter
Dust is not being
sucked off
Vacuum is not switched on Turn on vacuum before milling
Suction hose or suction adapt-
er ( 20) is clogged
Remove clogging