Parkside PMBA 20-Li B2, Translation Of The Original Instructions

Page: 15 / 163

PMBA 20-Li B2 GB
│
IE
│
9 ■
♦ Slide the saw blade
6
into the guide rollers
7
with the saw teeth pointing upwards. Make sure
that the guide rollers
7
firmly grip the saw
blade
6
.
NOTE
► Make sure that the direction arrow on the
saw blade
6
(if any) is the same as the one
on the rubber wheels
u
.
♦ Place the saw blade
6
around the two rubber
wheels.
♦ Retighten the saw blade clamping lever
8
by turning it anticlockwise again.
♦ Replace the protective cap
t
.
WARNING! RISK OF INJURY!
► Do not operate the appliance without the
protective cap
t
fitted!
♦ Perform a test run by briefly switching the appli-
ance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
► Keep your body away from the sawing
area during the test run!
Getting started
Switching the appliance on/off
Switching on:
♦ Press the safety lock-out
2
and keep it pressed
and then press the ON/OFF switch
3
.
♦ After starting, the safety lock-out
2
can be
released again.
♦ The LED work light
a
lights up when the ON/
OFF switch
3
is pressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
Switching off:
♦ Release the ON/OFF switch
3
.
Setting the rotational speed
♦ Adjust the speed adjustment wheel
1
to a
position between 1 and 6.
Working procedures
♦ Secure the workpiece against slipping, e.g.
with a vice.
♦ Use the weight of the saw when sawing. Do not
exert any additional pressure.
♦ Wait until the saw has reached its full speed
before carefully bringing it into contact with the
workpiece.
♦ If the saw blade
6
blocks, switch off the appli-
ance immediately.
♦ Do not twist the saw blade
6
while making
the cut.
WARNING! RISK OF INJURY!
► Do not remove the workpiece until the saw
has come to a standstill.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■ Store the appliance and the saw blades in a
dry and dust-free location.
■ The appliance must be kept clean and free
of oil or grease.
■ Use a dry cloth to clean the housing.
■ Never obstruct the ventilation openings.
■ Use a brush to remove any sawdust that has
stuck to the appliance.
NOTE
► Replacement parts not listed (such as switches
or saw blades) can be ordered via our
Service Hotline.