Parkside PKZ 180 C5, Original Instructions Manual

Page: 21 / 88

PKZ 180 C5 ■ 18
│
GB
│
IE
Cutting:
♦ Pull back the sleeve on the quick coupler of
the compressed air hose and remove the
compressed air connector .
CAUTION!
► Caution! When disconnecting the quick
coupler of the compressed air hose , hold
the coupler firmly to prevent injuries caused
by the hose flying off.
Inflation
with adapter
Schrader valve
Area of use:
This application allows for a simple and accurate
inflation. The manometer is used to check the
tire pressure. Thanks to the integrated release valve
it is possible to reduce the tire pressure if it is
too high.
ATTENTION!
► The manometer is calibrated. However, we
recommend that you check the tyre pressure
promptly with a suitable device at a petrol
station or motor vehicle workshop.
♦ Ensure that the ON/OFF switch is set to "O".
♦ Press the lever quick coupler downwards to
attach it.
♦ Place the lever quick coupler onto the valve
and then release the lever.
♦ Insert the mains plug of the compressor into
a mains power socket.
♦ Switch the ON/OFF switch to "I". The inte-
grated control lamp lights up.
♦ Pull the trigger .
♦ Read the air pressure from the manometer .
♦ Let the trigger off again.
♦ Switch the ON/OFF switch to "O" as soon
as the correct or permissible air pressure has
been reached. The integrated control lamp
goes out.
♦ Press down the lever quick coupler and pull
it off the valve.
♦ Remove the mains plug from the mains
power socket.
using the valve adapter
Sclaverand valve
Dunlop valve
Area of use:
The valve adapter facilitates easy inflation of
bicycle tires.
♦ Use the valve adapter to pump to the valves
shown above.
♦ Connect the valve adapter into the lever
quick coupler and then release it.
♦ Start by pressing the valve adapter onto the
valve.
♦ Inflate as described above.
using the ball needle /
universal adapters
Area of use:
The ball needle can be used to inflate various
balls. The universal adapters can be used to
inflate air mattresses or similar.
♦ Press the lever quick coupler downwards to
attach it.
♦ Insert the ball needle or one of the universal
adapters into the lever quick coupler
and then release it.
♦ Inflate as described above.