GB/MT
45
Troubleshooting
Fault
Possible cause
Remedy
Motor does not work.
Motor, cable or plug defective, fuses burnt.
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check fuses
and replace as necessary.
The motor starts up slowly
and does not reach
operating speed.
Voltage too low, coils damaged, capacitor burnt.
Contact the utility provider to check the voltage. Arrange
for inspection of the motor by a specialist. Arrange for
replacement of the capacitor by a specialist.
Motor makes excessive
noise.
Coils damaged, motor defective.
Arrange for inspection of the motor by a specialist.
The motor does not reach
its full power.
Circuits in the network are overloaded (lamps,
other motors, etc.).
Do not use any other equipment or motors on the same
circuit.
Motor overheats easily.
Overloading of the motor, insufficient cooling of
the motor.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
Reduced cutting power
when sawing.
Saw blade too small (ground too much).
Readjust end stop of the saw unit.
Saw cut is rough or wavy. Saw blade dull, tooth shape not appropriate for
the material thickness.
Resharpen saw blade and/or use suitable saw blade.
Workpiece pulls away
and/or splinters.
Excessive cutting pressure and/or saw blade not
suitable for use.
Insert suitable saw blade.
Summary of Contents for PKS 1500 A2
Page 5: ...Fig 5 28 29 6 2 3 27 26 1 34 Fig 4 Fig 5 Fig 7 32 31 Fig 7 Fig 6 30 33 Fig 6...
Page 64: ...59 DE AT CH...
Page 66: ...147 148...
