38
GB/IE
again you must first remove the welding
slag at the welding position.
ATTENTION!
A voltage which is 10% below the rated
input voltage of the welding device can
have the following consequences:
The power to the device will reduce.
The arc stops or becomes unstable.
ATTENTION!
The arc radiation can lead to inflam-
mation of the eyes and skin burns.
Casting and welding slag can cause
eye injuries and burns.
Wear tinted safety goggles or a
protective mask.
The safety mask must meet the
EN175 safety standards.
It is essential that you only use the
welding cable which is included with
the delivery (10 mm
2
).
z
Welding
Choose between push and drag welding. The following section shows the impact of
the direction of movement on the properties of the weld seam:
Push welding
Drag welding
Burn
smaller
larger
Weld seam width
larger
smaller
Weld bead
flatter
higher
Weld seam fault
larger
smaller
Note:
You decide for yourself which
type of welding is most suitable, once
you have welded a sample piece.
Note:
Once it has worn down com-
pletely, the electrode must be replaced.
z
Maintenance and
cleaning
Note:
The welding device must be
regularly serviced and overhauled for
proper function and for compliance with
the safety requirements. Improper and
wrong operation may cause failures and
damage to the device.
Before performing cleaning work on
the welding tool, disconnect the
power cable
10
from the power
Using the device / Welding / Maintenance and cleaning
331996_Inverter_Schweissgeraet_PISG_120_A2_content_LB8.indb 38
331996_Inverter_Schweissgeraet_PISG_120_A2_content_LB8.indb 38
17.12.2019 14:19:08
17.12.2019 14:19:08
