Parkside PHKSA 12 A1, Translation Of The Original Instructions

Page: 11 / 50

PHKSA 12 A1 ■ 8 │
GB
│
IE
│
NI
│
CY
■ Do not allow the teeth of the saw blade to
overheat .
■ When sawing plastic, avoid melting the plastic .
■ Wear a dust mask when sawing .
■ Only use recommended saw blades .
■ Always wear hearing protection!
Safety information for circular saw
blades
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear hearing protection!
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
Original accessories/auxiliary
equipment
■ Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.
Before use
Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger .
NOTE
► The battery is supplied partially charged .
Before first use, charge the battery in the
charger for at least 1 hour . This guarantees
full battery performance . You can charge the
lithium-ion battery at any time without short-
ening its service life . Interrupting the charging
process does not damage the battery .
► If the battery overheats during operation, it
cannot be charged immediately . Allow it to
cool down first .
■ Never charge the battery pack if the
ambient temperature is below 10°C or above
40°C .
1 . To remove the battery pack , press the release
button and pull the battery pack out of the
appliance .
2 . Insert the battery pack into the high-speed
charger .
3 . Insert the mains plug into the socket . The control
LED lights up red .
4 . The green charge status indicator LED indicates
that the charging process is complete and the
battery pack is ready .
5 . Insert the battery pack back into the appliance .
Checking blade guard functionality
♦ Pull the release lever for the blade guard as
far as it will go .
The blade guard should move without jamming .
When letting go of the release lever for the blade
guard , it should automatically jump back to its
original position .
Operation
Fitting/changing the saw blade
Always remove the battery pack before changing
the saw blade !
1 . Set the cutting depth (using the locking screw )
to the minimum position, 0 mm .
2 . Swing the blade guard back using the
release lever and put the appliance down .
3 . Press the spindle lock button (until it engag-
es) and hold it in .
IB_302329_PHKSA12A1_LB6-.indb 8 29.03.18 13:44