10 GB
Original accessories /
auxiliary equipment
Only use the accessories and additional
equipment which are specified in the oper-
ating instructions and compatible with the
appliance.
Initial use
Always activate switch lock
1
to
lock the trigger
2
and disconnect
the product from the mains before
starting any works on the product.
Adding staples
Turn the product over.
Squeeze the release button
3 a
(see Fig. B).
Then pull out the push rod
3
from magazine
4
(see Fig. B).
Add staples to the magazine
4
(see Fig. C).
After adding staples, slide the push rod
3
back to the magazine
4
till it is closed.
Release button
3 a
must click and lock in
place with the magazine
4
properly.
Note:
Use the window on the fill indicator
5
or
7
to check if the magazine
4
is empty. You can
use both fill indicators to check whether there are
still staples in the magazine.
Adding nails
Turn the product over.
Squeeze the release button
3 a
(see Fig. B).
Then pull out the push rod
3
from magazine
4
(see Fig. B).
Follow icon
shown on push rod
3
and
add nails to the magazine
4
(see Fig. D).
After adding nails, slide the push rod
3
back
to the magazine
4
till it is closed. Release
button
3 a
must click and lock in place with
the magazine
4
properly.
Note:
Use the window on the fill indicator
7
to
check if the magazine
4
is empty.
Functions
Stapling and nailing
Press down switch lock
1
completely from
right to left to unlock position .
Press the safety contact
6
into the work
piece (see Fig. E).
Squeeze the switch trigger
2
whilst holding
the product against the work piece to drive
a staple / nail into it.
Note:
Hold product firmly and press on work
surface before firing to ensure complete penetra-
tion of the staple / nail.
Clearing jammed
staples or nails
Always activate switch lock
1
to
lock the trigger
2
and disconnect
the product from the mains before
starting any works on the product.
Open the magazine
4
and pull out the
push rod
3
.
Remove the jammed staple or nail from the
magazine
4
.
Choosing the correct length
of nails and staples
Consider 2 factors to choose the correct
length for staples and nails:
- the thickness of the material to be fastened
- the composition and hardness of the base
material.
Summary of Contents for PHET 15 C2
