Parkside PHD 135 A1, Translation Of The Original Instructions

Page: 10 / 34

10
GB IE NI
standard Vario nozzle (11) by screw-
ing in with the jet pipe (15).
7. Screw in to connect the detergent con-
tainer with nozzle (19) directly to the
spray gun (9). With using the cleaning
agent container with the nozzle (19),
pour only cleaning agent into the con-
tainer. It is sucked in automatically.
The width of the jet can be in -
creased by turning the end of the
nozzle to the left. To reduce the
width of the jet, turn the end of the
nozzle to the right.
Mains connection
The pressure cleaner you have acquired
is already fitted with a mains plug. The
equipment is designed for connection to
an earthed wall socket with a residual
current operated device (RCD switch) at
230 V ~ 50 Hz.
Only operate the pressure cleaner
after all the above points have been
observed.
1. Ensure that the pressure cleaner is
turned off by its ON / OFF switch (3).
2. Insert the mains plug into the mains
socket
Operation
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing firmly and that you
are holding the gun (9) se-
curely, otherwise you could
injure yourself or other
people.
Never operate the pressure cleaner
with a closed water tap. Dry run-
ning will damage the pressure
cleaner!
1. Turn on the water tap entirely.
2. Switch on the pressure cleaner with the
ON / OFF switch (3).
Only ever switch on the pressure clean-
er once you have connected all of the
water pipes and they do not leak.
The motor switches on until the re -
quired pressure has built up. After
the pressure has built up, the motor
switches off.
3. Press the gun (9) starting lever (13).
The nozzle operates by pressure and
the motor switches back on.
Releasing the starting lever (13) causes
the equipment to switch off. The system
remains pressurised.
• The turbo dirt blaster (22) produces a
rotating water jet and is designed for
low water consumption work.
• The standard Vario nozzle (11) pro -
duces a flat wide jet particularly suited
for large surfaces.
Turn the tip of the nozzle left to reduce
the width of the jet. Turn the tip of the
nozzle right to expand the width of
the jet.
In the event of leaks in the
water system, switch off the
equipment immediately at
the on/off switch (3) and dis-
connect the equipment from
the mains at the mains pow-
er cord. Risk of electric shock!
Start afresh with making the
water connections (cf. “Start-
up / Operation” from
point 2.).
If there is still air in the device,
please proceed as follows:
To vent the supply hose:
1. Remove the water connection (7) and
turn the water tap on until the water
comes out without bubbles.