Parkside PFBS 12 B6, Translation Of The Original Instructions

Page: 15 / 258

PFBS 12 B6 ■ 12 │
GB
│
IE
Stop charging
♦ Disconnect the USB mains adapter from the mains power supply.
♦ Disconnect the USB charging cable from the charging socket on the appliance.
CAUTION!
► Never recharge a battery again immediately after charging. There is a risk that the
battery will become overcharged.
Checking the battery charge level
If the appliance is switched on, the remaining charge will be shown on the battery LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Changing/inserting the tool/collet chuck
♦ Press the spindle lock and hold it down.
♦ Turn the tensioning nut until the lock clicks into place.
♦ Undo the tensioning nut from the thread using the combination spanner .
♦ Remove any attached tool.
♦ First push the intended tool through the tensioning nut before inserting it into the
appropriate collet chuck for the tool shaft.
♦ Press the spindle lock and hold it down.
♦ Push the collet chuck into the thread insert and screw the tensioning nut tight with
the combination spanner .
NOTE
► Use the screwdriver side of the combination spanner to undo and tighten the
screw on the mandrel .
Switching on and off/setting speed range
Switching on/setting the speed range
♦ Set the On/Off switch to the position “I”.
♦ Set the speed control to a position between “1” and “MAX”.
Switching off
♦ Set the On/Off swtch to the position “O”.