GB/IE/NI
12
liquid into a fine spray.
Use compressed air that is clean, oil-free and dry
for the device. Ensure that you do not set the pres-
sure to a value higher than the maximum working
pressure for this device.
z
z
Using the device
z
Remove any objects and debris from the sur-
face to be cleaned.
z
Turn the valve
5
to the vertical position to
allow the addition of the liquid in the cleaning
liquid tank
4
to the liquid-air mix. The valve
5
is continuously adjustable: depending on
the position of the valve
5
, more or less
cleaning liquid will be mixed with the air.
z
Maintain a distance of around 1-3 cm from the
surface to be cleaned
z
To start using the pneumatic cleaning gun,
press and hold the trigger
3
.
z
For best results, move the brush
7
repeatedly
in a smooth, circular motion over the surface to
be cleaned
z
Release the trigger
3
when you have finished
your work.
z
After finishing your work, wipe down the sur-
face with a dry cloth, switch off the compressor
and disconnect the compressed air hose from
the gun.
z
After finishing work, unscrew the cleaning
liquid tank
4
from the gun and dispose of the
contents in an environmentally-friendly manner.
z
z
Care and cleaning
Maintenance must be performed by
properly trained personnel only.
Inspect the pneumatic cleaning gun at regular
intervals: there should be no cracks or damage
and the nozzle
8
should be in perfect working
order.
Do not continue to use the pneumatic cleaning gun
if you notice any safety-relevant abnormalities. In
this case, please contact a specialist.
Cleaning the nozzle
z
Turn the valve
5
to the horizontal position and
press the trigger
3
to clean the nozzle
8
with compressed air.
z
If the nozzle
8
becomes heavily soiled,
remove the brush
7
by turning it anticlock-
wise. Remove the nozzle
8
and clean it with
plain water.
General
z
Before each use, check to confirm that no
liquid has condensed inside the compressed
air hoses.
z
When cleaning the pneumatic cleaning gun,
use plain water — do not use aggressive
detergents. Turn the valve
5
to the horizontal
position so that only air comes out of the gun
when the trigger
3
is pressed. Immerse the
pneumatic cleaning gun and the brush in a
container filled with plain water. Press the
trigger
3
to remove the dirt from the brush
7
and the nozzle
8
.
z
Empty the cleaning liquid tank
4
after each
use.
z
Store the pneumatic gun in a clean and dry
place, and protect from frost.
z
After each use, wipe down the pneumatic gun
with a clean, dry cloth.
WARRANTY AND SERVICE
INFORMATION
Warranty from Creative Marketing
Consulting GmbH
We give you a warranty on this device of 3 years
from the date of purchase. In the event of product
defects, you have legal rights against the retailer of
this product. Your statutory rights are not affected
in any way by our warranty conditions, which are
described below.
Operation / Warranty and service information
Summary of Contents for PDRP 6.2 A1
Page 3: ...A 4 5 7 6 2 1 3 B 8...
Page 4: ......
