GB
IE
NI
9
A system separator (check valve) prevents
the backflow of water and detergent into
the drinking water pipeline.
• Employ an ordinary garden hose for
the water intake and ensure sufficient
length.
• Use the device on a domestic water
connection with maximum pressure of
5 bar.
• You can also use the device indepen
-
dently of the water pipe (for example,
with a rain barrel) through the integrat-
ed water suction function. This function
must only be used with a suction hose
with a filter basket.
Connecting the water
supply
Connecting to the domestic
water connection
1. Connect the supply hose to the water
supply. Bleed the hose by allowing wa-
ter to flow bubble-free out of the other
end of the supply hose. Close the tap.
2. Connect the hose coupling of the supply
hose to the water connection (4) on the
device.
If you have installed a coupling
with a waterstop function on your
water supply, remove this coupling.
Exhaust without the coupling and
then install the coupling again.
Suctioning water
• You can also use the device indepen
-
dently of the water pipe (for example,
with a rain barrel) through the integrat-
ed water suction function. This function
must only be used with a suction hose
with a filter basket.
The device itself must not be immer
-
sed in open water sources. There
is a risk of personal injury from an
electric shock.
Do not draw in any water from na-
tural accumulations. There is a risk
of contamination from backwashed
cleaning agent.
1. Connect the suction hose with filter bas
-
ket to the coupling (11) on the device.
2. Insert the end with the filter basket into
the water collector (e.g. rain barrel).
Ensure there is a sufficient and reliable
water supply.
Weight down the filter basket so that
it sinks in the water.
When suctioning, the device may
run dry
temporarily
.
Bleeding the hose
Make sure that there is no air in the suction
hose. Immerse the suction hose and filter
basket (11) completely into the water col-
lector (e.g. rain barrel) to bleed it.
Dry running will damage the device
Inserting/removing the
rechargeable battery
1. To
insert
the battery (13) into the
device, push the battery (13) along the
guide rail into the device. You will hear
it click into place.
2. To
remove
the battery (13) from the
device, press the release button (14)
on the battery and pull the battery (13)
out.
Summary of Contents for PDRA 20-Li A1
Page 3: ...15 14 13 A 1 2 3 4 5 7 6 9 8 10 11 12...
Page 28: ...28...
