PDFW 120 A1
GB
│
IE
│
NI
│
CY
│
13
■
Fitting tools onto the flexible shaft
♦
Push the black collar all the way back onto
the flexible shaft to lock the spindle . Note
that the collet chuck mount is loosened in an
anticlockwise direction . Hold the black collar
in this position .
♦
Use the combination spanner to undo the
collet chuck mount on the flexible shaft .
♦
Fit the tool and screw the collet chuck mount
back into place .
♦
Release the black collar .
Changing the collet chuck
You can change the collet chuck if the shaft
diameter of the tool you want to use is different .
♦
Push the black collar all the way back onto
the flexible shaft to lock the spindle . Note
that the collet chuck mount is loosened in an
anticlockwise direction . Hold the black collar
in this position .
♦
Use the combination spanner to undo the
collet chuck mount on the flexible shaft .
Unscrew the collet chuck mount .
♦
Remove the collet chuck and replace it with
a collet chuck with the desired diameter .
♦
Replace the collet chuck mount back on the
flexible shaft . Screw the collet chuck mount
tight using the combination spanner .
♦
Release the black collar .
Using the work arbor for cutting discs
♦
Use the screw driver side of the combination
spanner to undo and tighten the screw of the
work arbor for cutting discs .
♦
Fit the work arbor for cutting discs as
described into the flexible shaft .
♦
Use the combination spanner to undo the
screw on the work arbor for cutting discs .
♦
Fit the desired cutting disc / onto the
screw between the two washers .
♦
Use the combination spanner to tighten the
screw on the work arbor for cutting discs .
Use the work arbor for polishing felts
♦
Screw the tip of the work arbor for polishing
felts clockwise into the corresponding hole
in the polishing felts / .
♦
Fit the work arbor for polishing felts as
described into the flexible shaft .
Using the work arbor for abrasive belts
♦
Push the required abrasive belt / com-
pletely onto the corresponding work arbor for
abrasive belts / .
♦
Use the combination spanner to tighten the
screw on the work arbor / to fasten the
abrasive belts .
♦
Fit the work arbor for abrasive belts / as
described into the flexible shaft .
Notes on working with materials/
tools/speed range
■
Never use the appliance for other purposes
and only use original parts/accessories . Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury .
■
Determine the rotational speed range for work-
ing on zinc, zinc alloys, aluminium and copper
by trying it out on test pieces .
■
Use a low rotational speed for work on plastics
and materials with a low melting point .
■
Use a high rotational speed for working on
wood .
■
Carry out cleaning, polishing and buffing work
in the medium speed range .
The following are recommendations only and not
binding . When carrying out practical work, carry
out your own tests to see which tool and which set-
tings are ideal for the material you are working on .
