Parkside PDAP 75 A1, Translation Of The Original Instructions

Page: 72 / 106

PDAP 75 A1
GB
│
MT
│ 69 ■
♦ Use the pressure reducer on the compressed air source to set
the optimum working pressure . Note that the maximum working
pressure may not be exceeded . An excessive working pressure
does not mean increased output; it merely increases the air con-
sumption and accelerates appliance wear . Always comply with
the technical information .
NOTE
► Do not apply the polish too often to the same surface as the
particles it contains could damage the finish .
► Mask any plastic components beforehand as these could be
brightened by the polish .
♦ Switch the compressed air polisher on .
♦ Guide the compressed air polisher parallel onto the workpiece .
♦ Move the appliance parallel to and evenly over the surface being
polished .
♦ Do not press down on the compressed air polisher . Pressing
down hard does not increase the working efficiency!
♦ When you are satisfied with the result, release the trigger to
switch off the appliance .
♦ When you have finished working, disconnect the appliance from
the compressed air source .
CAUTION!
► Depending on the size and nature of the workpiece, suitable
safety precautions must be taken . Use suitable clamps to pre-
vent the workpiece from slipping .
► In the event of an interruption to the air supply, release the
trigger immediately .