Parkside PBH 800 A1, Original Instructions Manual

Page: 39 / 54

PBH 800 A1 ■ 36 │
GB
│
MT
NOTE
► Turn the additional handle into the various
locking positions depending on your working
position . Undo and lock the additional han-
dle as described previously .
Depth stop
♦ Undo the wing screw .
♦ Insert the depth stop into the additional
handle .
♦ Ensure that the toothing on the depth stop is
facing downwards .
♦ Pull the depth stop out until the distance
between the tip of the drill and the tip of the
depth stop with the required drilling depth .
♦ Retighten the wing screw afterwards .
Fitting/removing a tool
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Fitting a tool:
♦ Before fitting a tool, grease the tool holder
lightly with machine grease .
♦ To insert, pull the locking collar backwards
and insert the tool .
♦ Release the locking collar . This locks the
tool holder . Check that the tool is properly
locked by pulling it . The system has radial play
because of the design .
Removing a tool:
♦ To release the tool, pull the locking collar
backwards .
Quick­release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck for
hammer drilling or chiselling!
♦ Set the function selector switch to the drill
symbol .
Inserting the quick-release chuck for round
shaft drill bits:
♦ To insert the quick-release chuck (see also
fig . A) pull the locking collar backwards .
Insert the quick-release chuck .
♦ Release the locking collar . This locks the
tool holder . Check that the tool is properly
locked by pulling it .
Removing the quick-release chuck for round
shaft drill bits:
♦ To remove the quick-release chuck , pull the
locking collar backwards and remove the
quick-release chuck .
Use
Select operating mode
Function selector:
♦ Press and hold the release button on the
function selector switch . Turn the function
selector switch so that the required symbol
engages at the arrow mark:
Function Symbol
Drilling/screwing
Hammer drilling
Chiselling
Chisel position adjust-
ment
Adjusting chisel position:
You can rotate the tool to the required position for
chiselling using this function .
♦ Turn the function selector switch to position .
♦ Turn the tool in the tool holder to the required
position .
♦ Turn the function selector switch to position
for the chiselling function .