Parkside PBH 1050 B2, Translation Of The Original Instructions

Page: 29 / 44

PBH 1050 B2 ■ 26
│ GB
│
MT
Original accessories / auxiliary
equipment
■ Only use the accessories and additional
equipment which are specified in the
operating instructions and are compatible
with the appliance.
Operation
Additional handle
NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached .
► The appliance is fitted with an LED .
This lights up red as soon as the appliance is
connected to the power supply .
This indicates that the appliance is connected
to the power and that it will turn on immedi-
ately if the ON/OFF switch is pressed .
♦ The position of the additional handle can be
adjusted . Turn the wing screw anti-clockwise
and swivel the additional handle into the
desired position .
♦ Then tighten the wing screw again .
Depth stop
♦ Open the wing screw .
♦ Insert the depth stop into the additional
handle .
♦ Ensure that the toothing on the depth stop is
facing upwards and downwards .
♦ Pull the depth stop out far enough for the
distance between the tip of the drill and the tip
of the depth stop to correspond with the
required drilling depth .
♦ Retighten the wing screw afterwards .
Fitting/removing a tool
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Fitting a tool:
♦ Before fitting a tool into the tool holder ,
grease it lightly .
♦ To insert, pull the locking collar backwards
and insert the tool .
♦ Release the locking collar . This locks the
tool holder . Check that the tool is properly
locked by pulling it . The system has radial play
because of the design .
Removing a tool:
♦ To remove the tool, pull the locking collar
backwards .
Quick­release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck for
hammer drilling or chiselling!
♦ Set the function selector switch to the drill
symbol .
Inserting the quick-release chuck for round
shaft drill bits:
♦ To insert the quick-release chuck (see also
fig . A) pull the locking collar backwards .
Insert the quick-release chuck .
♦ Release the locking collar . This locks the
tool holder . Check that the tool is properly
locked by pulling it .
Removing the quick-release chuck for round
shaft drill bits:
♦ To remove the quick-release chuck , pull the
locking collar backwards and remove the
quick-release chuck .