15
GB/IE
WEAR PROTECTIVE GLOVES!
Leaked or damaged
batteries / rechargeable batteries can cause burns on
contact with the skin. Wear suitable protective gloves
at all times if such an event occurs.
This product has a built-in rechargeable battery which cannot
be replaced by the user. The removal or replacement of the re-
chargeable battery may only be carried out by the manufacturer
or his customer service or by a similarly qualified person in order
to avoid hazards. When disposing of the product, it should be
noted that this product contains a rechargeable battery.
Before use
Charging the product
Note:
Remove all packaging materials from the product.
Note:
You can recharge the product using a normal household socket.
Note:
To use the product without an adapter, you must first charge the
integral rechargeable battery. It takes 5–7 hours to charge the inte-
gral batteries. The rechargeable battery is permanently installed in
the handle of the product.
Note:
Charge the product for approximately 12 hours before first use.
Note:
Charge the product at least once a month, if it is to remain
unused for an extended period of time.
Only connect the product to a properly installed USB socket by SELV
adaptor with max. 5 V
(Uout) 500 mA.
Note:
If the product has not been charged for an extended period
of time (approx. 2 months), you could find that the integral recharge-
able battery has entered a dormant state. Charge and discharge the
product a number of times in succession to reactivate the integral
rechargeable battery.
Insert the USB connector of the USB cable
8
into the USB input
socket of the product.
Then insert the USB plug of the USB cable
8
into the USB port
on USB power supply.
Note:
The product has an overcharging protection system. Never-
theless, you should disconnect the product from the mains once the
charging process is complete.
Note:
The charging indicator
5
illuminates red during the charging
process. When the charging process is complete, the charging indicator
5
illuminates green.
Use
CAUTION – RISK OF ACCIDENT!
If at all possible, do not use
the product in a moving vehicle. If the product is used in a vehicle, it
must not be allowed to endanger the safety of the driver or passengers.
Always store and secure the product in such a way that there is no
risk of injury from or damage to the product, even during full braking.
Note:
You can secure the product by using the hook
1
or the mag-
netic base
4
on a flat, ferromagnetic surface. Use the joint
7
to tilt
the product up to approx. 180° on the magnetic base
4
. The strip
light
2
can be rotated to a desired angle.
CAUTION!
Please note the position of your hands whilst turning the
magnetic holder to prevent pinching your fingers (see Fig. C).
Using the product disconnected
from a power supply
Fully charge the product, as described in the section on
“Charging the product”.
The product can be operated in 3 different modes, select these
by repeatedly pressing the ON / OFF switch
3
.
Summary of Contents for PATC 2 B1
Page 3: ...A 7 1 4 8 3 2 B 5 6 C ca approx env 180 ...
Page 4: ......