PAMFW 20-Li A1
GB
│
9
■
Fitting the sanding sheet onto the
sanding plate
♦
Place the sanding sheet centrally on the
sanding plate .
Changing tools
NOTE
►
If you plan to use the dust extraction unit, it
must be connected before fitting or changing
the tool (see . section "Connecting a dust
extraction unit") .
WARNING! RISK OF INJURY!
■
Always remove the battery before working on
the power tool .
♦
If necessary, remove an already fitted tool .
To do this, raise the tool release lever .
♦
Fit the tool (e .g . the plunge saw blade ) onto
the tool holder .
NOTE
►
You can fit the tools in any snap position on
the tool holder .
♦
Lock the tool into place by pushing the tool
release lever back down again .
■
Check that the tool is fitted firmly.
Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury .
Use
Switching on and off
Switching on:
♦
Push the ON/OFF switch forwards to switch
the appliance on .
The LED work light lights up when the appli-
ance is switched on to light up the working area
in low light conditions .
NOTE
►
The LED work light can only be used when
the dust extraction unit is not fitted .
Switching off:
♦
Push the ON/OFF switch backwards to
switch the appliance off .
Selecting oscillation speed
♦
Use the speed adjustment wheel to set the
required oscillation speed .
Level 1: low speed
♦
Level 6: high speed
NOTE
►
The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests .
IB_302784_PAMFW20-LiA1_LB6.indb 9
13.03.18 09:07