Parkside PABK 60 B3, Operation And Safety Notes

Page: 19 / 39

16 GB/IE/NI
Cleaning and care / Warranty and service information Cleaning and care
Cleaning and care
Thoroughly clean the spray stylus
3
immedi-
ately after use. Otherwise the paint can dry
and cause problems during the next use.
Rinse out the spray stylus
3
thoroughly with
water. Do the same with the mini paint spray
gun.
Note: should the compressor's air duct be
dirty, remove the sucked in dirt using a dry
cloth.
ATTENTION!
Never submerge the paint spray gun in solvents.
After each use, spray thinner (only in the open
air – danger of explosion!) or water through
the device.
Use a cleaning brush or a cloth. to clean the
casing, the nozzle head and the spray holes
contained within. Never use petrol, solvents or
cleaning agents that attack plastic.
First screw out the material amount regulation
screw by turning in an anticlockwise direction.
Remove the spring.
Remove the needle using pliers (see Figure A).
Clean the needle carefully using the brush
(tooth / nail brush) (see Figure B).
Put the needle back in the paint spray gun.
Place the spring on the end of the needle.
Error Interrupted paint jet
or intermittent
colour coverage
Cause Solution
1. Paint almost
empty
1. Fill paint
2. Viscosity too
high
2. Lower viscosity
3. Nozzle loose /
defective
3. Replace / screw nozzle
tight
Screw the material amount regulation screw
tight by turning in a clockwise direction.
Unscrew the gravity flow cup from the mini spray
gun by turning in an anticlockwise direction.
Remove the filter as shown in Figure C and
clean this with a tooth / nail brush.
Also clean the gravity flow cup's inner screw
thread using a tooth or nail brush (see Figure D).
Insert the filter back into the gun (see Figure C)
and screw the gravity flow cup tight in a clock-
wise direction.
For rust protection you can spray sewing
machine oil through the device after cleaning.
For this purpose, spray sewing machine oil in
through the spray gun.
Oil all moving parts regularly to ensure the
smooth operation of the device.
After cleaning the needle, the thread and seal
must be lightly greased.
Do not use any lubricants containing silicone.
Only store pneumatic tools in dry areas.
Error Reduced performance
Cause Solution
4. Paint supply
restricted
4. Clean
5. Spray stylus
3
in incorrect
position
5. Correct angle of
position
Error Spray pattern not
complete
Cause Solution
1. Air head dirty /
defective
1. Clean / replace air
head
1. Rinse with clear water
2. Contaminated /
defective nozzle
2. Clean / replace nozzle
Error Spray pattern
irregular with
formation of drops
Cause Solution
1. Defective nozzle 1. Replace nozzle.
Go to a suitable service
station for this purpose.
2. Viscosity too high 2. Lower viscosity
285126_Airbrush-Set PABK 60 B3_content_IE.indd 16 14.06.17 16:34