Parkside BJ 2002, Operating And Safety Instructions Manual

Page: 7 / 10

INSERTING / CHANGING CHUCKS
WARNING: Pull out the mains plug before changing attachments.
Never engage the spindle lock
(Fig. p) until the tool has stopped.
1. Gently turn the chuck (Fig. p) and press the spindle lock until it engages.
2. Unscrew the chuck and replace it with another chuck or clamp.
INSERTING TOOL / ATTACHMENTS IN CHUCK
WARNING: Pull out the mains plug before changing any attachments.
Never engage the spindle lock
(Fig. p) until the tool has stopped.
1. Gently turn the chuck (Fig. p) and press the spindle lock until it engages.
2. Slacken the chuck and change the attachment.
Insert attachments so that as little as possible projects beyond the end of the chuck. Too long a projecting tool shaft bends
easily and can lead to vibrations.
TIPS AND TRICKS
• Do not exert use too much force when using your model-making and engraving set.
If you use too much pressure you could break the bits or damage the object on which you are working.
• Make sure the accessories you use are clean and sharp.
• If at all possible, attach the object on which you are working to a secure, stable surface.
• Use lower speeds for metal than for hard- or softwood.
• Plastic can melt at the contact points so you should only work on plastic with very low speeds.
• If vibrations occur with a correctly inserted attachment, then you should carefully increase the tool operating speed.
You can find further practical tips in the accompanying booklet "Safety Advice".
We reserve the right to make technical modifications in the course of further development.
STATEMENT OF CONFORMITY
We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare that this product
conforms with the following EC regulations:
EC machine guideline/
EC low voltage regulations:
Electromagnetic compatibility:
Applicable harmonised standards:
Model type: KL-C102
Description: POWER ADAPTOR
Bochum, 30.06.2002
Hans Kompernaß - Managing Director -
7
73/23 EEC, 93/68 EEC (Low Voltage Directive)
89/336 EEC (EMC Directive)
EN 55014-1:2000, EN 55014-2:1997
EN 61000-3-2:2000, EN 61000-3-3:1995
EN 61558-1:1997+1998
EN 61558-2-6:1997