![background image](http://html1.mh-extra.com/html/parkside/6-v/6-v_operating-and-safety-instructions-manual_4119344006.webp)
8 GB/IE/CY
To avoid danger to life from
electric shock:
J
A damaged drill / grinder, mains
lead or plug presents a serious dan-
ger to life from electric shock. Check
the condition of the drill / grinder, charger, mains
lead, mains plug and battery pack at frequent
intervals. Do not use a drill / grinder with dam-
aged parts. If a dangerous situation arises pull
out the mains plug from the socket immediately.
Never open up the drill / grinder or equipment.
Always have any repairs carried out or replace-
ment parts fitted at the service centre or by an
electrical equipment repair specialist.
J
Protect the charger, battery pack and the drill /
grinder from moisture.
J
Warning!
Do not use the drill / grinder with
chargers or batteries other than the charger /
battery pack supplied.
J
Warning!
Never short circuit the battery
pack. Overheating, fire or destruction of the
battery pack may result.
Therefore:
- Do not connect any wires to the battery
pack poles.
- Take care that no metal objects (nails,
screws, etc.) can short circuit the battery pack
connectors.
J
m
Attention!
Never throw the battery pack
into fire or water. Danger of explosion! Handle
the battery pack with care, protect it from im-
pacts and sharp blows!
Attention! To avoid the danger
of injury, burning and damage
to health:
J
Warning!
If you come into contact with the
acid from the battery pack, wash off the acid
thoroughly with water immediately. If acid
should enter your eyes, flush them immediately
with water and find a doctor immediately.
J
Caution!
The tool continues to
rotate after it has been switched off!
Avoid contact with rapidly rotating
drill / grinder components.
J
When you use the drill / grinder wear
the following protective equipment:
safety glasses and protective gloves.
To work safely:
J
Before cleaning or maintaining the charger or
battery pack always pull the plug out of the
mains socket.
J
Never charge the battery pack if the ambient
temperature is below 10 °C or above 40 °C.
m
Attention!
To avoid damaging the tool or
workpiece.
J
Do not allow the tool to come to a standstill by
overloading it!
Q
Operation
Q
Charging the battery pack
m
Attention!
A battery pack that has been
unused for a while or never been charged must be
charged before reuse or first use. The battery pack
requires about 3-5 cycles before it can reach its
full charge.
m
Attention!
Always pull out the mains plug
(mains adapter
9
) before you insert the battery
pack into or take it out of the charger.
j
Connect the adapter
9
to a mains socket.
j
Insert the battery pack
3
into the charging
cradle
8
. Make sure that the polarity of the
battery pack matches that of charging cradle
8
.
j
The LED
10
lights up green whenever the bat-
tery pack
3
is in the charging cradle
8
and
the adapter
9
is connected to a mains socket.
J
Do not use the quick-charge process to charge
a battery pack for a second time in close suc-
cession. Otherwise there is the danger that the
battery pack will become overcharged and its
useful life and that of the charger reduced.
Safety / Operation