Parkside 384512 2107, Translation Of The Original Instructions

Page: 46 / 64

PBH 1050 C3
GB
│
MT
│ 43 ■
Depth stop
♦ Undo the screw on the depth stop .
♦ Insert the depth stop into the additional
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
♦ Pull the depth stop out until the distance
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Tighten the screw on the depth stop to
lock the depth stop into place.
Fitting/removing a tool
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool
♦ Before fitting a tool into the tool holder ,
grease it lightly.
♦ To insert, pull the locking collar backwards
and insert the tool.
♦ Release the locking collar . This locks the tool
holder . Check that the tool is properly
locked by pulling it. The system has radial play
because of the design.
Removing a tool
♦ To remove the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck
for hammer drilling or chiselling!
♦ Set the function selector switch to the drill
symbol .
Inserting the quick-release chuck for round
shaft drill bits
♦ To insert the quick-release chuck (see also
fig. A) pull the locking collar backwards.
Insert the quick-release chuck .
♦ Release the locking collar . This locks the
tool holder . Check that the tool is properly
locked by pulling it.
Removing the quick-release chuck for round
shaft drill bits
♦ To remove the quick-release chuck , pull the
locking collar backwards and remove the
quick-release chuck .