Parkside 374065 2104, Translation Of The Original Instructions

Page: 10 / 64

10
IE CY GB NI
Therefore, proceed cautiously and hold
the workpiece fi rmly in order to avoid
slipping which could cause your hands to
come into contact with the grinding disc.
• The workpiece gets hot during grinding.
Do not touch the machined area, allow
it to cool down. There is a risk of burn-
ing. Do not use coolants or the like.
• If you are tired or have consumed al-
cohol or tablets, do not work with the
device. Always have a break on time.
• Switch the device off and remove the
mains plug
- to loosen a blocked insertion tool,
- if the connection line is damaged or
entangled,
- in case of unusual sounds.
• Always use the protective hood, work-
piece support, viewing window and
spark arrester as required for the at-
tachment tools.
• Only use attachment tools with a dia-
meter corresponding to the required
marking.
• Always use the power tool with attach-
ment tools on both spindles to limit the
risk of contact with the rotating spindle.
Residual risks
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this elec-
tric tool may present the following hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear protec-
tion is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding discs.
the event that it is damaged or severed,
immediately disconnect the plug from
the socket.
Do not touch the cable before it has
been disconnected from the mains. Risk
of electric shock.
• The replacement of the plug or the con-
nection line must always be executed
by the manufacturer of the electric tool
or his/her customer service in order to
avoid any hazards.
• Only switch the device on once it is
safely fi xed to the worktop.
• For your own safety only use acces-
sories and attachments which were
stated in the operating instructions or
recommended or specifi ed by the tool
manufacturer.
• Only use grinding tools recommended
by the manufacturer. Do not use any
saw blades. Ensure that the dimensions
match those of the device.
• Never operate the device without spark
protection or protective hoods.
Periodically readjust the spark protection
in order to offset the wear and tear of
the grinding disc (distance max. 2 mm).
• Replace the grinding disc if the spark
protection and the workpiece support
can no longer be readjusted to a dis-
tance of max. 2 mm at the latest.
• Make sure that the sparks produced by
grinding do not present a danger, e.g.
reach people or ignite fl ammable sub-
stances.
• Always wear safety goggles, safety
gloves, respiratory protection and ear
protection when grinding.
• Never keep the fi ngers between the
grinding disc and spark protection
or in close proximity to the protective
hoods. There is a risk of crushing.
• The rotating parts of the device cannot
be covered due to functional reasons.