![background image](http://html1.mh-extra.com/html/parkside/364251-2010/364251-2010_operation-and-safety-notes_758357010.webp)
10 GB
Note:
Digital manometer has auto-off function,
whenever product stays alone without pressing
any functional button for about 30 seconds, it
will switch off automatically to save battery
energy.
Connecting and removal of
adaptor nozzle (see fig. D)
Press down lock lever
11
of connector
10
.
While pressing down lock lever
11
, insert
adaptor nozzle into the hole of connector
10
in direction a till it is completely reaching
the bottom of the hole.
Then release lock lever
11
.
To remove the adaptor nozzle by pres-
sing down lock lever
11
and pull out the
adaptor nozzle in direction b by comple-
tely away from the connector
10
.
Inflating an item
Check LCD display panel
2
reading is
set to zero before connecting to item to
be inflated.
Connect to the valve of the item to be
inflated securely.
Press down trigger
8
to process inflation
operations.
Monitor the pressure reading from LCD
display panel
2
.
Till reaching desired pressure, release
trigger
8
to stop inflation.
Remove the adaptor nozzle from the
valve of the item to be inflated.
Regulating pressure
If there is too much air inflated into the
item or reaching pressure higher than
desired. Press down pressure release
button
6
to release some of the air to
regulate the pressure.
Always disconnect the
inflator from the compressed air source after
finishing the work to avoid expelling high
pressure air to people or animal by accident
that may cause personal injury.
Changing the batteries
(see fig. B)
When battery level is low it needs to be
replaced by new one. Always replace both
batteries.
Remove the battery compartment cover
16
on the rear side of digital manometer
1
.
Remove the exhausted batteries
15
from
battery compartment
17
.
Put the new batteries
15
into battery com-
partment
17
. Check the polarity of the
battery is correctly connected.
Close the battery compartment
17
by
replacing the compartment cover
16
.
Maintenance
DANGER OF IN-
JURY!
Always disconnect the product
from the compressed air supply before
cleaning it. The product does not require
special maintenance.
Cleaning
Do not use sharp objects to clean the
product.
Do not allow liquids to get inside the
product, this can cause damage to it.
Clean the product regularly. The best time
to do so is right after completing works.
Clean the product housing with a dry
cloth.