Parkside 360432 2010, Operation And Safety Notes

Page: 20 / 101

20 GB/CY
Faults Cause of fault Troubleshooting
Indicator lamp
does not lit up?

No electrical connection.

ON/OFF switch set to off.

Check whether the device is
connected to the socket.

Set switch to ON.
Ventilator does
not work?

Power line interrupted.

Power line ventilator faulty.

Ventilator faulty.

Check whether the device is
connected to the socket.
Warning lamp
switches on?

Overheating protection
switched on.

Input voltage too high.

Allow device to cool down.

Input voltage according to
type plate.
No output
current?

Machine faulty.

Overvoltage protection
activated.

Machine must be repaired.

Allow device to cool down.
Output current
does not
decrease?

Input voltage too low.

Connection cable cross-section
too low.

Observe input voltage
according to type plate.
Arc stops during
cutting?

Cutting speed too low.

Plasma burner 8 is held too
high and too far away from
the material.

Plasma burner component
parts are worn
8b , 8c , 8d , 8e .

Workpiece no longer
connected to the grounding
cable.

Increase the cutting speed until
the problem no longer exists.

Lower the plasma burner 8
to the recommended height.

Check and replace worn
parts.

Check the connections.
Insuffi cient
Penetration?

Cutting speed too fast.

Burner sleeve 8c is not straight

Metal is too thick.

Plasma burner component
parts are worn
8b , 8c , 8d , 8e .

Slow down the working speed

Adjust the inclination.

Several cycles necessary.

Check and replace worn
parts.
Air current cannot
be regulated?

Compressed air hose
damaged or faulty.

Valve/manometer fails.

New connection of the hose.
HF-arc is not
created?

The burner switch is faulty.

Soldering point on the burner
switch or plug loosened.

Valve/manometer fails.

Renew electrode.
Bad ignition?

Burner wear parts damaged
or worn.

Change wear parts.
Troubleshooting