Parkside 360196 2007, Translation Of The Original Instructions, Page: 16 / 140

PWSA 20-Li C3 GB
│
CY
│
11 ■
■
Always remove the battery during work
breaks, when adjusting the appliance and
when it is not in use.
The appliance must be
kept clean, dry and free of oil and grease at
all times.
■ Remain alert at all times! Always pay atten-
tion to what you are doing and act with
common sense.
Do not use the appliance if
you are distracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should
be checked regularly. The optimum charge
level is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Connect the battery pack to the high-speed
charger (see fig. A).
♦ Insert the power plug into the socket. The
control LED lights up red.
♦ The green LED indicates that the charging
process is complete and the battery pack is
ready.
ATTENTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Allow the battery pack to click into the
handle.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the protective cover for cutting
When cutting with bonded abrasives, always use
the protective cover
8a for cutting.
♦ Slide the protective cover 8a onto the blade
guard (see fig. E) until the plastic clip “X”
snaps into place at the end.
♦ When removing the protective cover 8a ,
press the plastic clip “X” in slightly to release
the protective cover
8a
.