PMFW 310 D2
■
44
│
GB
│
MT
A1
Scraper Z52 A1
Materials
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removal of material residues, such as tile
adhesive, when replacing damaged tiles
Changing tools
NOTE
►
If you plan to use the dust collection unit, it
must be connected before fitting or changing
the tool (see section “Connecting a dust
extraction device”).
WARNING! RISK OF INJURY!
■
Always remove the plug from the power
socket before working on the power tool.
■
Check that the tool is fitted firmly. Incorrectly or
insecurely fitted tools can come loose during
use and cause you an injury.
■
If necessary, remove an already fitted tool.
To do this, raise the tool release lever .
■
Fit the tool (e.g. the plunge saw blade ) onto
the tool holder.
NOTE
►
You can fit the tools in any snap position on
the tool holder.
■
Lock the tool into place by pushing the tool
release lever back down again.
Fitting the sanding sheet onto
the sanding plate
Attaching
♦
Sanding sheets are attached to the sanding
pad by means of the hook and pile
fastening.
NOTE
►
Before fitting a new sanding sheet , remove
any dust and dirt from the sanding pad .
►
Note that the holes for dust extraction from
sanding sheet and sanding pad are
aligned.
♦
Position the sanding sheet flush on one side
of the sanding pad , then place the sanding
sheet on the sanding plate.
Operation
Switching on and off
Switching on
♦
Push the ON/OFF switch forwards to switch
the appliance on.
Switching off
♦
Push the ON/OFF switch backwards to
switch the appliance off.
Selecting oscillation speed
♦
Use the speed adjustment wheel to set the
required oscillation speed.
Level 1: low speed
Level 6: high speed
NOTE
►
The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.