Parkside 339157 1910, Instructions Manual

Page: 47 / 190

PDKS 6.3 B3
■ 44 │
GB
│
IE
Fitting/changing the saw blade
CAUTION!
► If the saw blade is blunt, bent or defective, it must be
replaced immediately .
► When changing the saw blade , always make sure that the
compressed-air supply is disconnected!
♦
First open the cover using a Phillips screwdriver .
♦
Then use the enclosed 4 mm hex key to loosen the hexagon
socket screws for the saw blade holder and remove the
saw blade .
♦
Then set the new saw blade into the saw blade holder
and tighten the hexagon socket screws for the saw blade
holder firmly .
♦
Make sure that the saw blade is correctly fitted in the saw
blade holder and can no longer be pulled out .
♦
Then close the cover again using the Phillips screwdriver .
Adjusting/changing the stop bracket
♦
Loosen the hexagon socket screw for the stop bracket using
the enclosed 2 mm hex key .
After loosening the hexagon socket screw the stop bracket
can be removed by pulling .
♦
Now an adjustment or a complete exchange of the stop
bracket is possible .
♦
After changing or adjusting the stop bracket , retighten the
previously loosened hexagon socket screw using the 2 mm
hex key .