PAMFW 20-Li A1
GB
│
IE
│
21
■
Working procedures
Working principle
The oscillating drive causes the application tool to
move back and forth at a speed of 5000–19000
times per minute. This allows for precision work
even in confined spaces.
Sawing/cutting
■
Use only undamaged saw blades that are in
perfect working order. Bent, blunt or otherwise
damaged saw blades may break.
■
When sawing lightweight construction mate-
rials, follow the statutory regulations and all
recommendations from the material manufac-
turers.
■
Only soft materials such as wood, plasterboard
or similar should be processed using the plunge
saw process.
Sanding
■
To prolong the service life of the sanding
sheets , ensure that you apply even pressure.
Before use
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦
Push the battery pack into the handle until it
clicks into place.
Removing the battery pack
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
♦
Connect the battery pack to the high-speed
battery charger (see Fig. A).
♦
Insert the power plug into the socket.
The control LED lights up red.
♦
The green LED indicates that the charging
process is complete and the battery pack is
ready.
CAUTION!
♦
If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦
If the red and green control LEDs both
flash, this means that the battery pack is
defective.
WARNING! RISK OF INJURY!
■
Always remove the battery before working on
the power tool.
♦
Push the battery pack into the appliance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
IB_339108_PAMFW20-LiA1_LB8.indb 21
09.03.20 11:55
Summary of Contents for 339108 1910
Page 3: ...6 5 4 Z52 A1 Z64 B2 HCS C A...
Page 5: ...20V max 18V...