![background image](http://html1.mh-extra.com/html/parkside/337334-2007/337334-2007_translation-of-the-original-instructions_758340009.webp)
PMK 550 A1
■
6
│
GB
│
IE
Before use
WARNING! RISK OF INJURY!
►
Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Changing the die holder position
(see fig . A)
The die position can be adjusted by 360° .
Four working positions offset by 90° are specified .
The working positions can be set as follows:
♦
Loosen the hex screw using the supplied hex
key .
♦
Turn the die holder into the desired working
position so that the respective hole in the die
holder is facing towards the hex screw .
♦
Retighten the hex screw using the supplied
hex key .
♦
Rotate the die holder slightly to check whether
it is fixed in the correct position .
Permissible material thickness
The maximum cutting capacity depends on the
material quality and strength .
The measuring grooves and on the die
holder can be used as a thickness gauge for the
permissible cutting thickness .
Never cut material thicknesses greater than those
specified in the technical data .
Fitting and removing the grooved pin
and the die holder (see figs . B + C)
♦
To remove the grooved pin and the die
holder
, undo the hex screw using the
supplied hex key .
♦
Pull the die holder from the appliance .
♦
Loosen the hex screw using the supplied hex
key so you can remove the grooved pin
from the tool holder .
♦
Insert the new supplied grooved pin into the
tool holder so that the hole in the grooved
pin is facing towards the hex screw .
♦
Tighten the hex screw firmly to secure the
grooved pin in place .
♦
Guide and insert the die holder via the tool
holder back into the appliance .
♦
Turn the die holder into the desired working
position so that the respective hole in the die
holder is facing towards the hex screw .
♦
Retighten the hex screw using the supplied
hex key .
♦
Rotate the die holder slightly to check whether
it is fixed in the correct position .
Operation
Switching on/off
Switching the appliance on
♦
Move the ON/OFF switch to the "0" position .
Switching the appliance off
♦
Move the ON/OFF switch to the "I" position .
Lubrication
♦
Apply standard machine oil to the cutting line
to extend the service life of the grooved pin
and the die .
This is particularly important when cutting
aluminium .
Summary of Contents for 337334-2007
Page 3: ...A B C ...