Parkside 332669 1907, Operating Instructions Manual

Page: 29 / 118

PWM 4 A1
■ 26
│
GB
│
IE
Operation
The appliance has three memory functions that meter the amount of water consumed.
The modes on the display
show the amount of water consumed either in litres or gallons.
♦ Press the button to activate the display .
♦ Press the button repeatedly to switch to one of the other display modes.
♦ Press the button to switch between litres and gallons.
TOTAL 1
■ The water quantity is counted until it is reset (e.g. water consumption per day).
TOTAL 2
■ The water quantity is counted until it is reset (e.g. water consumption per season).
AUTO
■ The water quantity is counted per watering process up to an interruption of 3 seconds.
During the next watering process the display starts again at 0.
LITER/MIN or GAL/MIN
■ In this mode, the current flow rate is displayed in l/min or gal/min.
NOTE
► If no water flows through for longer than approx. 1 minute or if you do not press any key,
the appliance switches to standby mode.
► Press the button again to activate the display .
Reset
♦ Press the button for 3 seconds in TOTAL 1/TOTAL 2 or AUTO display mode to reset
the water quantity measurement to 0. You only reset the water quantity measurement for the
display mode you are currently in.
Dismantling
♦ Unscrew the appliance or tap connector anticlockwise from the water connection. When
using a garden sprayer or similar, push the front part of the coupling to the rear and pull
off the garden sprayer.
♦ Disconnect the water hose from the water hose connection .