Parkside 324013 1901, Translation Of The Original Instructions

Page: 27 / 104

PMSA 12 B2 ■ 22 │
GB
│
IE
♦ Proceed in reverse order to fit a new cutting
disc . Make sure that the ground side of the
cutting disc is facing outwards .
WARNING!
► If there is a direction of rotation arrow on
the cutting disc, it must match the direction of
rotation arrow on the appliance .
► Do not tighten the clamping screw too
tightly . The cutting disc could break .
Operation
WARNING! RISK OF INJURY
► Note that the cutting disc runs on for a little
while .
Switching on and off
Switching on:
♦ Slide the On/Off switch to position 1 .
Switching off:
♦ Slide the On/Off switch to position 0 .
Battery charge level
♦ The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Handling the appliance
♦ Move the appliance forward slowly and without
exerting too much pressure .
♦ Make sure that the cutting disc does not come
to a standstill .
♦ Keep thin materials, such as fabric, under
tension while working them .
Cutting line marking
♦ Draw the desired pattern in advance on the
material you are working .
♦ Use the cutting line marking to orient your-
self on the previously marked pattern .
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch off the appliance and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free .
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ Never allow liquids to get into the appliance .
■ Use a dry cloth to clean the housing . Never use
petrol, solvents or cleansers which can damage
plastic .
■ Always keep the area around the blade guard
clean . Remove dust and chips by blowing them
out with compressed air or with a brush .
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
► Replacement parts not listed (such as batter-
ies, battery charger) can be ordered via our
service hotline .
Disposal
The packaging is made from environmen-
tally friendly material and can be
disposed of at your local recycling plant .
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner .
Do not dispose of batteries in your
normal household waste!