PASSK 20-Li A1
■
20
│
GB
│
IE
Safety instructions specifically for
impact screwdrivers
■
Wear hearing protection when impact
screwing.
Exposure to loud noise can lead
to hearing loss.
■
Secure the workpiece!
A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■
Hold the power tool firmly.
High torques can
occur for brief periods while tightening and
loosening screws.
■
Wait until the power tool has come to a stand-
still before putting it down.
The tool can jam,
this leading to loss of control of the power tool.
■
Hold the power tool by insulated gripping sur-
faces, when performing an operation where
the fastener may contact hidden wiring.
Fasten-
ers contacting a “live” wire may make exposed
metal parts of the power tool “live” and could
give the operator an electric shock.
Safety guidelines for battery chargers
■
This appliance may be used by
children aged 8 years and above
and by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks. Do not allow
children to use the appliance as a
toy. Cleaning and user maintenance
tasks must not be carried out by
children unless they are supervised.
■
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for indoor use
only.
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
ATTENTION!
Hot surface.
There is a risk of burns.
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger.
■
Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
♦
Connect the battery pack to the high-speed
battery charger (see Fig. A).
♦
Insert the power plug into the socket. The control
LED lights up red.
♦
The green LED indicates that the charging
process is complete and the battery pack
is ready for use.
CAUTION!
♦
If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦
If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦
Push the battery pack back into the appliance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also dis-
connect the power plug from the mains power
socket.
Summary of Contents for 320332
Page 3: ...A ...
Page 18: ...PASSK 20 Li A1 14 DE AT CH ...