Parkside 302303, Operating And Safety Instructions Manual

Page: 14 / 72

9 GB
13. Troubleshooting
Fault Possible cause Remedy
1. Power tool does
not start
Power supply interrupted Check power supply by connecting another power tool
Power cord or plug defective Electrician must check the tool
Other electrical defect of the power tool Electrician must check the tool
2. Power tool does
not operate with
full power
Extension cord too long and/or cross-section too
small Use extension cord with permissible length and/or
adequate cross-section
Power supply (e.g. generator) voltage too low Connect power tool to an appropriate power supply
3. Poor operation
results
Sanding paper worn out Replace sanding paper
Abrasive plate worn out Replace abrasive plate by specialist
4. Considerable dust
formation
Brush edge (around the sanding disc) worn out Replace brush edge by specialist
Dust extraction not connected / switched on Connect / switch on dust extraction
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also
required for use as consumables.
Wear parts*: Carbon brushes, Grinding plates, Brush head, Sanding paper
* Not necessarily included in the scope of delivery!