30
GB
MT
injuries, we recommend that persons
with medical implants consult their
doctor and the manufacturer of their
medical implant before operating
the machine.
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved
Handle
For a simple holmm installation, select
cutting height 20 mm (see „Adjusting
the cutting height“).
B
1. Remove the two pre-installed
butterly nuts (2a) from the lawn
-
mower housing (7). Insert the
lower bar (3) into the slot on the
lawnmower housing (7).
2. Fix the bottom bar (3) using the
two screws and butterly nuts
(2a).
C
3. Tighten the loop handle (1) with
the enclosed carriage bolts (16)
and two locking levers for beam
attachment with washer (2b) to
the lower beam (3).
4. Clip the cable holders (10) onto
the lower bar (3) and the U-
shaped grip (1) and use them to
ix the appliance’s cable in place
(21). The cable holders (10)
should be arranged on the thin
part of the bar.
5. Adjust the angle of the U-shaped
handle (1) by releasing the lo-
cking lever (2b) and choosing
one of the three recommended
settings, which are shown next
to the locking lever (see detail
illustration).
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment. En-
sure that the appliance’s cable (21) is
not trapped.
Mounting the grass
collection bag
D
Loop the three tabs (22) over the
grass collection bag frame (23)
Operation
Hanging On/Removing the
Grass Bag
D
1. To hang on the grass bag (4),
lift the collision guard (9) and
hang on the grass bag. Fold the
collision guard (9) onto the grass
bag (4). It holds the grass bag in
the correct position.
2. To remove the grass bag (4), lift
the collision guard (9) and detach
the grass bag. Fold the collision
guard (9) back onto the mower
housing.
Do not work with the lawn-
mower without the collision
guard or lawn box. There is
a risk of injury.
E
Level gauge
The level gauge (17) is located on the side
of the grass catcher (4).
