Parkside 292167, Translation Of The Original Instructions, Page: 25 / 90

PDSS 16 A1 ■ 22 │
GB
│
IE
Switching on and off
Switching on:
♦ First, press the trigger lock forwards and
then the trigger down to switch the tool on .
Switching off:
♦ Release the trigger .
♦ When you have finished working, disconnect
the tool from the compressed air source .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may have accumulated on
the tool (due to working processes) . Avoid
all skin contact with these substances . If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis . If dust is
produced or swirled up during maintenance,
it can be inhaled .
NOTE
► To ensure correct functioning and a long
service life for the tool, pay attention to the
following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning .
■ Check the speed and vibration levels after each
use .
■ Check the idle speed regularly and after any
maintenance is performed:
use a rev counter and perform the measure-
ment without any clamped tools . At a residual
pressure of 6 .3 bar, the idle speed may not be
exceeded under any circumstances .
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired .
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk . In doubt, contact the
Service Centre .
■ Clean the tool with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents
under any circumstances .
Troubleshooting
Fault Possible
cause Remedy
Speed too
slow, air
escapes from
the outlet . Motor parts
jamming due
to dirt . Check the
pressure sup-
ply filter for
contamination .
Pressure sup-
ply too low . Check the
pressure sup-
ply filter for
contamination .
Lubricate the
tool as de-
scribed in the
instructions .
If necessary,
repeat the
steps outlined
above .
Tool does
not move;
compressed
air escapes
completely
through the
outlet . Motor is
jammed due
to material
build-up . Lubricate the
tool as de-
scribed in the
instructions .