PHKSA 20-Li A2
■
10
│
GB
│
IE
│
NI
Operation
Fitting/changing the saw blade
Always remove the battery pack before changing
the saw blade !
1. Set the cutting depth (using the locking screw
) to the minimum position, 0 mm.
2. Swing the blade guard back using the re-
lease lever and put the appliance down.
3. Press the spindle lock button (until it en-
gages) and use the hex key to release the
clamping screw . Now remove the clamping
screw and the clamping flange (see also
fig. A).
Fig. A: Changing the saw blade
4. Remove the saw blade .
5. Fitting a saw blade is carried out in the
reverse order.
6. Press the spindle lock button (until it engages)
and use the hex key to tighten the clamping
screw/washer .
WARNING!
►
The arrow on the saw blade must cor-
respond to the arrow showing the direction of
rotation
(running direction shown on the
blade guard ).
■
Ensure that the saw blade is suitable for the
rotational speed of the tool.
Rip fence
♦
Undo the wing screw and insert the rip fence
into the rip fence slot .
♦
Set the desired cut width with the help of the
scale on the rip fence and the cut out in the
base plate (see also fig. B).
The right recess in the base plate is for a cutting
angle of 0°. The left-hand recess in the base
plate is for a cutting angle of 45°.
Fig. B: Cutting width 3 cm
♦
Retighten the wing screw .
Connecting the sawdust extraction
device
♦
Attach the adapter for dust extraction to the
chip ejector .
Optional, depending on the diameter of the
dust and sawdust extraction.
♦
Connect an approved dust and chip extraction
device.
NOTE
►
When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance.
