PSBSA 20-Li A1
GB
│
IE
│
NI
│
7
■
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Push the rotation direction switch into the
middle position (lock) . Allow the battery pack
to click into the handle .
Removing the battery pack:
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to
check the status of the battery (see also main
diagram) .
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the additional handle
♦
Screw the additional handle onto the left or
right of the appliance depending on how you
work .
Changing tools
Your cordless screwdriver has a fully automatic
spindle lock
.
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . Once you have attached the desired tool
and tightened it by turning the chuck , you can
continue working . The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed) .
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque preselector
and select between the drill setting and the
hammer drill setting .
♦
Select a low level for small screws or soft
materials .
♦
Select a high level for large screws, hard
materials or removing screws .
♦
Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
♦
Select the hammer drill setting for hammer
drilling work by adjusting the torque selection
ring to the position .
2-speed gearbox
CAUTION!
►
Operate the speed selection switch only
when the appliance is at a standstill . Other-
wise the appliance can be damaged .
In first gear (speed selector switch
in
position: 1)
you can reach a speed of approx . 440 rpm and a
high torque . This setting is suitable for all screwing
work but also for the use of accessories .
In second gear (speed selector switch
in
position: 2)
you can reach a speed of approx . 1650 rpm for
carrying out drilling work .
