Parkside 285801, Translation Of The Original Instructions

Page: 13 / 47

PAMFW 20-Li A1
GB
│
IE
│
NI
│
CY
│ 9 ■
Fitting the sanding sheet onto the
sanding plate
♦ Place the sanding sheet centrally on the
sanding plate .
Changing tools
NOTE
► If you plan to use the dust extraction unit, it
must be connected before fitting or changing
the tool (see. section "Connecting a dust
extraction unit").
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool.
♦ If necessary, remove an already fitted tool.
To do this, raise the tool release lever .
♦ Fit the tool (e.g. the plunge saw blade ) onto
the tool holder.
NOTE
► You can fit the tools in any snap position on
the tool holder.
♦ Lock the tool into place by pushing the tool
release lever back down again.
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
Use
Switching on and off
Switching on:
♦ Push the ON/OFF switch forwards to switch
the appliance on.
The LED work light lights up when the appli-
ance is switched on to light up the working area
in low light conditions.
NOTE
► The LED work light can only be used when
the dust extraction unit is not fitted.
Switching off:
♦ Push the ON/OFF switch backwards to
switch the appliance off.
Selecting oscillation speed
♦ Use the speed adjustment wheel to set the
required oscillation speed.
Level 1: low speed
♦ Level 6: high speed
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■ Do not use any sharp objects to clean the ap-
pliance. Do not allow any liquids to get into the
appliance. This can damage the appliance.
■ Clean the appliance regularly, preferably im-
mediately after completion of the work.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.