20 GB/IE
Note:
Such mains adapters are available from
speciality retailers.
Check the water connection type available. The
product is fitted with a union nut
1
for a tap
with a 33.3 mm thread (G 1”). For a tap with a
26.5 mm thread (G ¾”) use the adapter sup-
plied
12
.
Insert the filter
11
into the union nut
1
as
depicted in Figure A..
For a 26.5 mm thread (G ¾”): Screw the
adapter
12
onto the tap. Do not use any tools
for this purpose.
Screw the union nut
1
onto the thread of the
tap or the adapter. Do not use any tools for this
purpose.
Screw the coupling
13
onto the hose connec-
tion
9
. You can then connect a hose to the
coupling
13
.
Open the tap.
Attention!
If defects / leaks arise when using
the adapter
12
, the thread of the tap must be
wrapped using sealing tape.
Open the protective cover to service the pro-
duct
3
. Close the protective cover
3
fully
afterwards.
Programme irrigation as described in the
chapter „Operation“.
Operation
Irrigation can be fully automated at any time of the
day using the irrigation controller. A sprinkler, sprinkler
system or drip irrigation system may be connected.
The irrigation controller automatically carries out
irrigation at the respective programmed start time
and for the programmed duration. Take the season
and time of the day into consideration when pro-
gramming. Evaporation and water consumption is
lowest early in the morning or late in the evening.
Switching the product on / off
(Fig. 1)
Press and hold down the ON / OFF button
8
for approx. 2 seconds to switch it on or off.
Note:
Automatic irrigation does not occur if
the product is switched off (see Fig. C). In a
switched-off state, however, irrigation may
occur manually (as described in the chapter
„Manual irrigation.“).
Adjusting the time (Fig. 2–6)
1. Switch on the product. Press and hold down the
ON / OFF button
8
for approx. 2 seconds.
2. Press and hold down the
button
4
for
approx. 2 seconds. The system time‘s hour
display will flash.
3. Set the hour by turning the rotary control
6
.
4. Press the
button
4
. The system time‘s minute
display will flash.
5. Set the minutes by turning the rotary control
6
.
6. Then press the
button
4
again to save.
Programme irrigation 1 and 2,
interval (Fig. 7–29)
Press and hold down the button
5
for approx.
2 seconds to activate programming mode. You
can either apply all settings one after the other,
or switch between the following setting options
by repeatedly pressing the button
5
:
Start time irrigation 1
Duration irrigation 1
Start time irrigation 2
Duration irrigation 2