Parkside Performance PWSAP 20-Li B2, Operation And Safety Notes Translation Of The Original Instructions, Page: 22 / 153

21 GB/CY
¾
The charging control LEDs (green 20 and
red 21) indicate the status of the charger 18
and the battery pack 5 :
LED Status
Red LED lights up Battery pack
charges
Green LED lights up Battery pack fully
charged
Green and red LED
flashing
Battery pack
defective
Red LED flashing Battery pack too
cold or too warm
Green LED lights up
(without battery pack)
Charger ready
¾
Insert the battery pack 5 into the charger
18 .
¾
Connect the power cord with power plug 19
of the charger 18 to the socket .
¾
When the battery pack 5 is fully charged:
Remove the battery pack from the charger
18 . Then disconnect the power cord with
power plug 19 of the charger from the
socket .
˜
Attaching/removing the
auxiliary handle
(Fig . E)
NOTE
u
The product may only be operated with
the auxiliary handle 6 fitted .
¾
Screw the auxiliary handle 6 , depending
on the type of work, to the left (a), right (b)
or on the top (c) of the product using the
auxiliary handle threads 2 .
˜
Adjusting the guard
(Fig . F)
m
WARNING!
Before adjusting the guard for grinding
8 : Switch the product off . Remove
the battery pack 5 from the product
to prevent the product from starting
unintentionally . Let the product cool
down before making any adjustments!
m
CAUTION! RISK OF INJURY!
Wear protective gloves . Be careful
when handling the guard for grinding
8 as there is a pinching hazard
between the guard and the wheel .
NOTE
u
The product must only be operated with
the guard mounted .
¾
Adjust the guard for grinding 8 such that
any sparks or detached parts cannot hit
either the user or any bystanders .
¾
The guard for grinding 8 must also be
positioned such that the sparks cannot ignite
combustible parts, including those in the
surroundings .
¾
Turn the guard for grinding 8 to the
required position . The clamp must engage in
one of the guard’s notches .