Parkside Performance PKLLP 360 B2, Operation And Safety Notes

Page: 14 / 89

14 GB
˜
Adjusting the tripod
(Fig . C)
NOTE:
You can use the dragonfly
[ 13]
to check the horizontal
alignment of the tripod .
1 . Pull the tripod legs
[ 7]
apart .
2 . Lock the tripod legs
[ 7]
into position with the locking ring
[ 9]
.
Setting the height, tripod feet
1 . Open the snap fasteners
[ 8]
.
2 . Extend the tripod legs
[ 7]
to the desired length .
3 . Close the snap fasteners
[ 8]
.
Setting the height, crank handle
1 . Fold up the crank handle
[ 10]
.
2 . Hold the crank handle
[ 10]
firmly with one hand .
3 . Unscrew the locking ring
[ 11]
by turning it to the left .
4 . Crank the tripod to the desired height .
5 . Turn the locking ring
[ 11]
to the right to lock this position .
Adjusting the inclination, forward/back
1 . Turn the handwheel bolt
[ 5]
to the left to loosen .
2 . Set the desired inclination .
3 . Turn the handwheel bolt
[ 5]
to the right to lock the inclination into
place .
Adjusting the inclination, sideways
1 . Turn the butterfly screw
[ 4]
to the left to loosen .
2 . Fold the tripod to the desired inclination .
3 . Turn the butterfly screw
[ 4]
to the right to lock into place .
Rotating the tripod
1 . Turn the adjusting screw
[ 12]
to the left to loosen .
2 . Hold the handwheel bolt
[ 5]
and turn the tripod in the desired
direction .
3 . Turn the adjusting screw
[ 12]
to the right to lock into place .