Parkray CONSORT 15, Instructions For Installation/Operating/Maintenance/Servicing

Page: 18 / 40

18
Please Note
Your Building Insurance Company may require you to inform them of this new installation and that the work has
been carried out correctly. Please check your policy to ensure that it is still valid when this installation is complete.
Using The Appliance For The First Time
When being heated up for the first time, smells and fumes are often produced. This is a normal chemical process
that allows the specialist heat resistant paint to cure and harden.
Please arrange for good ventilation of the room. Open windows and doors and if necessary, use a ventilator for fast
interchange of air. Heat up to operation temperature for at least one hour. If maximum temperature is not
achieved after heating up, release of odour may appear later.
Aerosols
Do not use an aerosol spray on or near the stove when it is alight.
Air Control
This stove has been designed to burn far more efficiently than a traditional stove if used correctly, with the obvious
notable feature of CLEAN GLASS. It is essential that the stove has an adequate air supply for combustion and
ventilation. The primary and secondary air inlets must be kept clear from obstruction and blockage.
Primary Air
This provides a conventional air draught to the bed of the fire.
Primary air is controlled via the slider(s) in the door(s).
To increase air, move the slider to the right. This provides a
conventional air draught to the bed of the fire.
Secondary Air
Secondary air is controlled via the
slider above the door(s); it is this
“Airwash” that keeps a clean and
uninterrupted view of the fire. The
amount of air can be increased by
moving the slider to the right.
Tertiary Air/Data Plate
Tertiary air aids in good secondary combustion of the fuel and reducing emissions into the chimney and
environment.
Data plate
Tertiary air can be controlled by adjusting the cover plate on the back of the stove.
Warning! – This Appliance will be hot when in operation and due care should be taken. We advise that suitable
gloves are used when operating the air control, and when opening the door
.
SAFETY ADVICE
During the first operation it is highly likely that fumes and smells maybe produced as part of the normal heat
resistant paint curing process, much like a domestic oven. Therefore, good ventilation during this process is
of utmost importance. We recommend that pregnant women, allergic persons and small children as well as
domestic animals, especially birds, should not unnecessarily stay in subjected areas.