Parklands PZT-42, Operator'S Manual

Page: 28 / 34

- 24 -
7.7.4 7.7.4 7.7.4 7.7.4 If the spring is not within this range,
release the parking brake and turn the
adjustment nut (B and C,Figure 23) to
compress or release the spring.
100mm
C
B
A
Figure 23
7.7.5 7.7.5 7.7.5 7.7.5 Engage the parking brake and
remeasure the spring.
8.
TROUBLESHOOTING TROUBLESHOOTING TROUBLESHOOTING TROUBLESHOOTING
WARNING
WARNING WARNING
WARNING
To To To To avoid avoid avoid avoid serious serious serious serious injury, injury, injury, injury, perform perform perform perform
maintenance maintenance maintenance maintenance on on on on the the the the tractor tractor tractor tractor or or or or mower mower mower mower only only only only
when when when when the the the the engine engine engine engine is is is is stopped stopped stopped stopped and and and and the the the the
parking parking parking parking brake brake brake brake engaged. engaged. engaged. engaged.
Always Always Always Always remove remove remove remove the the the the ignition ignition ignition ignition key, key, key, key, disconnect disconnect disconnect disconnect
the the the the spark spark spark spark plug plug plug plug wire wire wire wire and and and and fasten fasten fasten fasten it it it it away away away away
from from from from the the the the plug plug plug plug before before before before beginning beginning beginning beginning the the the the
maintenance, maintenance, maintenance, maintenance, to to to to prevent prevent prevent prevent accidental accidental accidental accidental
starting starting starting starting of of of of the the the the engine. engine. engine. engine.
While normal care and regular maintenance
will extend the life of your equipment,
prolonged or constant use may eventually
require a service to be performed to allow it
to continue operating properly.
The troubleshooting guide below lists the
most common problems, their causes and
remedies.
See the information on the following pages
for instructions on how to perform most of
these minor adjustments and service repairs
yourself.
If you prefer, all of these
procedures can be performed for you by
your local authorized dealer.
Problem
Problem
Problem Problem Possible
Possible
Possible Possible Cause
Cause
Cause Cause Corrective
Corrective
Corrective Corrective Action
Action
Action Action
Starter does
not crank
1.PTO is engaged.
2.Parking brake is not
engaged.
3.Drive levers are not in
neutral lock position.
4.Battery does not have a
full charge.
5.Electrical connections are
corroded, loose or faulty.
6.Fuse is blown.
7.Relay or switch is
defective.
8.Faulty module.
1.Disengage the PTO.
2.Set the parking brake.
3.Ensure the drive levers are in the
neutral lock position.
4.Charge the battery. See Check Battery
Charge and Recommended Jump Starting
Procedure sections in Maintenance.
5.Check the electrical connections for
good contact. Clean connector terminals
thoroughly with electrical contact
cleaner,apply dielectric grease and
reconnect.
6.Replace the blown fuse.
7.Contact an Authorized Service Dealer.
8.Replace module.