Parklands PZT-42, Operator'S Manual

Page: 12 / 34

- 8 -
�
Sand areas where paint is chipped and
repair to prevent rust. Lubricate all
locations to prevent moisture damage
during storage.
4.
ASSEMBLY
ASSEMBLY
ASSEMBLY ASSEMBLY INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS INSTRUCTIONS
4.1.
4.1. 4.1.
4.1. Uncrate
Uncrate Uncrate
Uncrate Mower
Mower Mower
Mower
4.2.
4.2.
4.2. 4.2. Install
Install
Install Install Roller
Roller
Roller Roller Protection
Protection
Protection Protection System
System
System System
Locate and align the ROPS with the
machine frame(Refer to Figure 3),
torque all the nuts to 50±5N.m
Figure 3
4.3.
4.3.
4.3. 4.3. Install
Install
Install Install Seat
Seat
Seat Seat
Locate and align the seat with the seat
pan (Refer to Figure 4), torque all the
nuts until the seat is snug.
Figure 4
4.4. 4.4. 4.4. 4.4. Install Install Install Install Steering Steering Steering Steering Lever Lever Lever Lever
4.3.1 4.3.1 4.3.1 4.3.1 Loosen and remove the two bolts
and springs which attach to the control
arm shaft .
4.3.2
4.3.2 4.3.2
4.3.2
Place the lever on the outside of
the control arm shaft and secure with
bolts and washers (Refer to Figure
5),tighten
until snug. Repeat on
opposite side of unit.
Figure 5
NOTE:
NOTE: NOTE:
NOTE:
There are two lever height options
available. Place the levers in the first and the
second hole (from the top) to increase height
of the levers, or in the second and the third
hole(from the top) to decrease the height of
the levers.
4.5. 4.5. 4.5. 4.5. Install Install Install Install Discharge Discharge Discharge Discharge Chute Chute Chute Chute
Locate the discharge to the mower
deck(Refer to Figure 5) and tighten knob
until chute is snug.
Figure 6