![background image](http://html.mh-extra.com/html/parking-facilities/pf8000/pf8000_manual_756560007.webp)
Manual Release Guide
kerb Maintenance
PF8000
Please use the following instructions to operate the kerb manually, the following
is assuming you have powered down the unit and opened the HPU cabinet door:
IMPORTANT NOTE
In order for the equipment to comply to the legislation/directives noted in this document it must be maintained and have a maintenance
schedule as documented in Regulation 5 of “The workplace health & Safety Welfare Regulations 1992"
As stated at the beginning of this manual we recommend a bi-annual service, but at a bear minimum, it is imperative that you get a service
done once every 12 months. This is not a sales tactic in disguise, there is a very serious health and safety issues/risks associated with not
complying to this. Also in order for your kerb to keep complying with the appropriate legislation.
Ÿ
Before carrying out any maintenance to the installation, disconnect the mains power supply.
Ÿ
Make sure you have disconnected/Isolated the power before attempting any work.
Ÿ
A Maintenance Contract should be sought from a specialist company after a maximum of 5000 manoeuvres or 1year from the install date.
Ÿ
Occasionally clean the photocell optical components and make sure they are free from dirt, water, rain, soil etc..
Ÿ
Have a qualified technician (installer) check the correct setting of the electric clutch.
Ÿ
If the power supply cable is damaged, it must be replaced by the manufacturer or its technical assistance service, or else by a suitably
qualified person, in order to prevent any risk.
Ÿ
When any operational malfunction is found, and not resolved, disconnect the mains power supply and request the assistance of a qualified
technician (installer). When automation is out of order, activate the manual release to allow the opening and closing operations to be
carried out manually.
Ÿ
Gearbox drive unit is “sealed” for life and requires no further lubrication.
!
PF8000
As Pictured above use the “Emergency lower valve” to release the blocker. Please ensure you have
turned the power off!
When this procedure is complete put the valve back to its home position to allow for normal operation
when the blocker is turned back on.
Summary of Contents for PF8000
Page 12: ...Loop Detector Settings PF8000 ...
Page 13: ...Loop Detector Settings PF8000 ...
Page 14: ...Loop Detector Settings PF8000 ...
Page 17: ...Hydraulic Oil Spec PF8000 ...