Parker VAC-35, Instructions Manual

Page: 9 / 19

6
OPERATING INSTRUCTIONS
READ SAFETY OPERATING INSTRUCTIONS BEFORE OPERATING EQUIPMENT
1. Heavy concentration of sand and gravel should
be avoided. These materials are extremely
abrasive, and while the VAC 35 will handle
moderate amounts of these materials, it is not
designed for heavy applications. Treat your
VAC 35 with reasonable care and it will repay
you with long, trouble-free service.
2. The VAC 35 will handle most common kinds
of debris found around industrial plants,
commercial buildings, homes, and farms. Acid
contaminated materials, magnesium, dust,
and other DANGEROUS DEBRIS that is
considered hazardous should not be handled
with the VAC 35.
3. The efficiency of this unit depends on the
breathing capacity of the dust bag. Under
extremely dusty conditions the bag should be
emptied and cleaned frequently. Always empty
and clean bag before storing after use. Debris
allowed to remain in the bag may cause
spontaneous combustion, resulting in an
explosion or fire. See instructions supplied
with dust bag.
DUST BAG CARE
1. To clean dust bag, turn the bag inside out and
reattach to unit.
2. Start engine and run at full throttle. Lightly tap
bag to release dirt trapped in the weave.
3. When clean, turn bag right side out and reattach
to unit.
4. Bag can be washed if extremely dirty.
TO START UNIT
IMPORTANT: Read the Engine Manual CAREFULLY
before operating the VAC 35. Before starting the
engine read and understand the following:
1. Be sure the engine crankcase is filled with the
proper type and amount of oil.
2. Spin-Pak® is in place.
3. Dust bag or discharge hose is in place.
4. Intake housing or hose kit is attached to the fan
housing.
TO STOP ENGINE
To stop the engine, Briggs & Stratton equipment,
move the Engine Throttle Control to the STOP
position. For Honda equipment, reduce engine speed
to slow, turn engine STOP control to off, on side of
engine. Remove any hearing protection and listen for
all moving parts to come to a complete stop.
LUBRICATION
Add a few drops of oil to the throttle control cable and
wire to help keep it operating smoothly.
Clearing the Machine of Clogs and Jams
A clog or jam in the machine can cause the vacuuming operation to decrease or even stop completely. If
this occurs, take the following steps:
STOP THE ENGINE IMMEDIATELY and disconnect the spark plug wire from the spark plug. Wait for all
moving parts to come to a complete stop.
Check (and clean, if necessary) the following areas in this order:
•
Check that the collection bag is not overfilled. Remove and empty bag.
•
While the bag is removed, check that the discharge deflector is not clogged or jammed. Use a stick to
clear away any debris.
•
Check that the vacuuming attachment is not clogged or jammed. Remove the attachment and thor-
oughly clean the opening. While the attachment is removed, check the inlet opening to the machine. Use
a stick to clear away any debris.