29
11.0 Setting Fresh Water Flush
The Aquamatic, Aquamatic XL and AquaWhisper desalination system controller allows you to configure
your desired fresh water flush program settings in two areas. The first area is in 'Runtime Settings', as
discussed previously. However, the same setting can also be adjusted in the dedicated 'FWF Settings' tab,
this tab also gives information about the current FWF system status, including the number of days until
the next flushing cycle will take place.
5.
Press system settings icon.
6.
Press FWF Settings.
Fresh Water Flush Frequency
This controls the sleep time between system fresh water flush cycles. Immediately after a system
shutdown, the fresh water flush program activates for a set duration. This flushing is done to
remove sea water from system components, and replace it with fresh water. However, it is vital
this fresh water be replaced every so often to ensure no biological growth can occur. The default
cycle time is 7 days, meaning each 7 days the fresh water flush program will repeat. Programmable
cycle times range from a minimum of 1 day to 15 days.
7.
Press Fresh Water Flush Frequency to change the default number of days between fresh water
Press here
Press here
Press on the
default
value to
change it.
Enter your
desired value
and press
'Enter'.
Summary of Contents for Sea Recovery Aquamatic
Page 19: ...19 ...
