Accessories
82 (109)
192-011006N8 2019-07
09.10.19 09:27
7.1.1.
Order code of motor cable
1
2
3
4
5
6
7
8
Ordering
example
CBM
015
H
D
M23
PSX
0150
00
1 Cables
CBM
Motor cable
2 Cross-section
007
0.75 mm
2
015
1.5 mm
2
025
2.5 mm
2
040, 060
4 mm
2
, 6 mm
2
3 Cable Type
H
HIPERFACE DSL® highly flexible
4 Brake wire
D
With brake wire and HIPERFACE DSL®
5 Assembly of motor side
M15
SpeedTec M15 (for motor connector - Order code YZ)
M23
SpeedTec M23 (for motor connector - order code IZ)
M40
SpeedTec M40 (for motor connector - Order code IZ
1)
)
XXX
Terminal Box
6 Assembly of drive side
PSX
PSD1-S & PSD1MW1800
PMX
PSD1-M (not PSD1MW1800)
7 Length [10 cm steps]
0100
Length in 10 cm (max. 50 m)
Example: 0025 = 2.5 m, 0205 = 20.5 m, 1020 = 102.0 m
Standard length [m]:
3 / 5 / 7 / 10 / 12 / 15 / 20 /25 / 30 / 35 / 40 / 45 / 50
8 Special design
00
Standard
1)
is required for Mx 205 series motors and Smx 170 60 Nm motors
7.2
EMC measures
In this chapter you can read about:
•
Mains filter ................................................................................................................................ 82
•
Motor output chokes ................................................................................................................. 84
7.2.1.
Mains filter
In this chapter you can read about:
•
Mains filters for PSD1-S single-phase ECP-0001-01 ................................................................ 83
•
Mains filters for PSD1-S 3-phases operation ECP-0002-01 ...................................................... 83
•
Mains filters for PSD1-M_P010 and PSD1-M_P020) ................................................................ 84
For radio disturbance suppression and for complying with the emission limit values
for CE conform operationwe offer mains filters:
Observe the maximum permitted length of the connection between the mains filter
and the device:
•
unshielded <0.5m;
•
shielded: <5m (fully shielded on ground e.g. ground of control cabinet)
